DuraTherm® Streetscape Asphalt Inlaid Surfacing System
Built Tough for High-Traffic Crosswalks
DuraTherm® is a specially-designed preformed thermoplastic material that is inlaid into imprinted asphalt using StreetHeat® asphalt reheating technology. The process of inlaying DuraTherm® into asphalt protects it from wear and ensures that it retains its attractive look for years. Communities across the country agree that DuraTherm® enhances both the beauty of their neighborhoods and pedestrian safety among shared roadway users.
DuraTherm® helps to:
Improve traffic safety especially at intersections and multi-use paths
Enhance visibility for motorists, cyclists and pedestrians
Promote and/or revitalize community image and pride
Channel pedestrians across busy commercial parking areas
Ennis-Flint trains and monitors a network of Certified Applicators so you can be confident that your design intentions will translate to fully-met expectations on the job site. Flint can help you choose the right applicator for your specific project.
Features & Benefits:
DuraTherm®, offers ADA compliance, fast installation, lower cost, and minimal maintenance compared to stamped concrete and pavers which can result in maintenance headaches, pedestrian hazards, slow installation, and lengthy traffic disruptions.
Fast Installation: Installations are performed by Certified Applicators who are trained for this specific technology. Crosswalks can be ready for traffic in as little as 90 minutes per lane.
High Skid/Slip Resistant: Anti-skid materials are added at time of manufacturing for a more consistent, controlled application.
• Designed specifically for high-traffic crosswalks
• Provides optimum wear in adverse conditions
• Snowplow friendly
• Eliminates the maintenance and safety concerns of loose pavers
Accessibility: DuraTherm® is inlaid to be flush with the asphalt. There is no additional vibration or rigid bumpy effect and, therefore, is wheelchair friendly.
Maintenance: Virtually maintenance free, but it is also easy to repair sections of material quickly and with minimal traffic disruption. Remove the damaged section, replace with new material, and heat in place.
Manufacturing Control: All DuraTherm® preformed thermoplastic materials are made at Flint’s manufacturing facility which is ISO 9001:2008 certified for design, development and manufacturing.
Incorporate Ennis-Flint's products into your plans quickly and easily by downloading our design files from CADdetails.com.